Mold remediation referrals for Tampa & nearby townsCall: (813) 437-5101
(813) 437-5101

Mold Inspection in Oldsmar, FL

moldremediationtampabay.net

At the top of Old Tampa Bay, Helene flooded some Oldsmar blocks and skipped others, so every house needs its own look.

Not sure how much water your Oldsmar home took?
Call now to be connected with a local mold remediation company in Oldsmar.
(813) 437-5101

An Oldsmar mold inspection gives you a measured answer about where water went and whether mold followed, instead of a guess. A state mold assessor checks walls, floors, the AC system and attic, then writes a scope. Call the number on this page to be connected with a local mold inspector in Oldsmar.

Inspector using a thermal camera on a stained ceiling, mold inspection in Oldsmar, FL

How the call and visit work

The number on this page connects you with an independent company in the area. Tell them what you've noticed, whether storm water came in, and when. On site, the assessor typically:

  1. Asks about the home's water history: roof work, plumbing repairs, past flooding
  2. Walks every room with a moisture meter, starting low on exterior and flooded walls
  3. Uses a thermal camera to find cool, damp areas behind finished surfaces
  4. Opens the air handler closet and checks the coil area, pan and drain line
  5. Looks at the attic for roof leaks and damp insulation
  6. Writes a report with photos, readings, the likely source and a room-by-room scope

Cost factors

Angi reports Tampa-area mold inspections typically fall between $300 and $1,075. Size and layout, attic access, how many rooms flooded and whether samples are requested drive the final number. HomeAdvisor lists Tampa-area testing at about $327 to $903 when sampling is part of the job. EPA's view is that sampling usually isn't needed when mold is visible, so ask the assessor what a lab result would change.

Call now to be connected with a local mold remediation company in Oldsmar.
(813) 437-5101
Inspector checking under a kitchen sink for moisture and mold, mold inspection in Oldsmar, FL

Local conditions in Oldsmar

Oldsmar sits on upper Old Tampa Bay, the "Top of the Bay," and Helene's surge in 2024 hit it unevenly. Parts of one neighborhood a few blocks off Tampa Road took several feet of water; on Shore Drive some homes were described as essentially totaled, and one garage held about four feet. Meanwhile streets along Tampa Road looked untouched, and several residents hadn't expected flooding that severe. That patchiness is why neighbors' experiences are a poor guide to your own house.

Most of the city's housing is newer than the Pinellas average, with a median year built of 1988 and about 23 percent built before 1980. Newer slab homes still trap water at the base of walls and in cabinets, and about 7.7 percent of units are mobile homes, which need a look underneath.

Before the assessor arrives

  • Make the attic hatch, air handler and under-sink cabinets reachable
  • Gather photos and dates from any storm or leak
  • Check the assessor's state license on DBPR's online search
  • Remember Florida's s. 468.8419: this assessor won't do your cleanup within 12 months
  • Rebuilding permits run through Pinellas County Building Services, which acts as Oldsmar's building official by agreement
  • Renters with unfixed leaks can contact the city's Code Enforcement Division

Mold Inspection questions in Oldsmar

What should the written report include?
Photos, moisture readings, the likely water source, affected areas marked by room, and a scope a remediation company can bid against. If samples were taken, the report should explain why.
Should I run the AC before the inspector arrives?
If you suspect the air handler or ducts are moldy, EPA advises not running the HVAC system because it can spread mold through the house. Otherwise leave things as they are and tell the assessor about recent leaks.
How do I check a mold assessor's license?
Ask for the state mold assessor license number and look it up on DBPR's online licensee search. Florida licenses individuals, so check the person who will actually do the work.
Should I get an inspection after floodwater came inside?
If wet drywall, insulation or flooring could not be dried within 24 to 48 hours, EPA says to assume mold is growing. An inspection maps how far the water wicked and what has to come out, but removing soaked materials shouldn't wait on a report.

More mold services in Oldsmar

Mold Inspection nearby

Call now to be connected with a local mold remediation company in Oldsmar.
(813) 437-5101

Last updated:

☎ Call (813) 437-5101